Slid your finger under the same section of plastic and contine to pull as you move towards the passenger side.
As you get towards the center you will feel plastic clips poping up to allow the section of plastic to come up.
Continue along all the way over to the passenger side.
Drivers side of the switch panel. Wire leaves the panel and is tucked behind the black rubber surrounding the windsheild.
Run the air line around the windsheild until you hit the dash and then back towards the center of the dash.
On my 2000 there is a small hole and the only hole I could find just to the left of the center section of my console.
Pull the air line down and just to right of the gas pedal there is a gromet high up near the orange line going through the firewall. If you dont have a 1997-2002 you might not have the same gromet.
On the engine comparement side the groment side is just to the left of your valve cover. Run it over to your air system if you have one. I connected mine to my ARB compressor into a quick disconnect fitting I installed for Embergency air a while back.
Use the supplied white zip tie holders and zip ties to secure the wiring loom.
Wiring
loom runs down the outter edge of the passenger side window.
Hits
the corner and slides behind the dash up against the fall wall.
Looking from the spare tire into the cab.
Side shot of the panel with the visors down. Yes thats real dust. With the visors up you hardly tell the panel is there unless you really look. Most people that ride with me dont even know its there.
Jeep®, Wrangler, Liberty, Wagoneer, Cherokee,
and Grand Cherokee are copyrighted and trademarked to Daimler-Chrysler Corporation.
Links4Jeeps.com is not in any way associated with the Daimler-Chrysler Corp.
All material obtained from Links4Jeeps.com
is strickly for reference only. Links4Jeeps.com does not warrant or assume
any legal liability or responsibility for the accuracy, completeness, or
usefulness of any information, or process disclosed.
